1/8 F16 1.81m (71.3″)

Pilot-RC is very pleased to announce the production of what is one of aviations most epic aircraft ever, the General Dynamics F16 Fighting Falcon.

We wanted this one to go above and beyond as a beautiful scale model. We found ways to make it reliable and tough enough to actually be flown on a regular basis, and not a problem to transport or put together, all in a package that fly’s brilliantly well.

This 1/8 scale version has been designed with an improved wing area, to provide better performance and flight characteristics.


Model:1/8 F16
Wingspan:52.9″ (1,344mm)
Length:71.3″ (1.81mm) – Plus pitot tube
Weight:17.8lbs (7.85kg) 


Build Video from Warren RC


*Please note that the production version comes with a clear canopy.


  • Full composite construction, lightweight and strong 
  • Two piece wing and two piece full flying stabiliser, both fully removeable
  • Painted outside the mold so no seam lines
  • Easily detachable ventral fins, helps in place with just two screws

Included hardware:

  • Complete air frame (including fibreglass control horns)
  • Carbon fibre wing-tubes
  • Servo extension leads
  • Fixed Dual wall thrust pipe (for 60-100N turbines)
  • Fuel tank (2000ml) and UAT (250ml)
  • Pre-prepared pushrods with ball links
  • Pre-glued control horns


  • Pilot-RC electric landing gear and brake set

Also available:

Landing gear combo

Pilot-RC 1/8 F16 kit with gear doors installed
Pilot-RC electric landing gear & brakes set 

Requires servos and turbine of choice.
Does not include vector thrust pipe or cockpit set

Turbine Ready Combo

Pilot-RC 1/8 F16 kit with gear doors installed
Pilot-RC electric landing gear & brakes set installed
Pilot-RC servos and extension wires, all installed
Standard dual wall thrust pipe, UAT, Kevlar fuel tank, fuel dot, fuel tank vent, all installed

Requires your own turbine of choice.

Required hardware:

Turbine: 60-100N 

Servos: x9

x5 middle size servo, 35 x 15 x 30mm (minimum 16kg) // Uses x1 per aileron, x1 per elevator, x1 on rudder

x4 middle size servo, 35 x 15 x 30mm (minimum 10kg) // Uses x3 for gear doors and x1 for steering

Also requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories.

Pilot-Rc recommended hardware:

Colour schemes available:

Colour scheme 02 : 

Colour scheme 03 : 

Colour scheme 04 : 

Colour scheme 05 : 


Control throws:

Aileron: 10mm up / 10mm down – 40% Expo
Measured from the wingtip

Rudder: 35mm left / 35mm right – 50% Expo

Elevator: 40mm up / 40mm down – 45% Expo
Measured from the front of the leading edge of the elevator.

The CG is 148mm from the front leading edge on the root of the wing

Elevator center position:
Center of the leading edge of the elevator should be 10mm above the bottom surface of the fuselage


Coming soon